Should I prime window rebates before glazing?
For standard single glazing, we recommend using linseed oil putty and painting it once a skin has formed. Linseed oil paint and putty should not come into direct contact with the edge seal of a glazing unit.
Should I back-prime timber siding?
Back-priming means treating the reverse side of siding before installation. Whether it is appropriate depends on the timber species, board construction, installation method and exposure. Discuss your siding project with our team before applying paint or primer to concealed surfaces.
What should I do if my linseed oil putty has dried out or developed mold?
Store putty in a tightly sealed container to prevent premature drying. If a surface skin develops, inspect the material beneath before use. If the putty shows signs of mold, unusual discoloration or a change in consistency, contact us before using it—we’ll advise whether it is still suitable.
Does linseed oil paint go over existing latex, alkyd or oil paint?
It will adhere to existing paint and primer—including latex, alkyd and pre-primed boards—but it will only perform as well as the coating underneath. To get the full moisture-wicking benefit, we always recommend removing the old paint first.
How do I prepare a previously painted surface?
Ideally, remove all existing paint. If that isn’t possible, sand lightly and paint straight from the can.
Which filler do you recommend?
For repairs up to about 3/8 in deep, use linseed oil putty. For larger holes, pack with oakum first and finish with putty.
Does linseed oil paint work over two-part or epoxy fillers?
Yes, as long as the filler is fully dry. Give it a light key before painting.
Can I paint timber stripped with Peelaway 7?
Usually, yes. It depends on how well the surface was rinsed and neutralized afterward—any residue left behind may react with the paint.
My windows and doors came pre-treated. Will linseed oil paint still work?
Yes, it adheres to existing paint and primer. For the best results, we recommend ordering new timber without any treatment.
My fences and garden furniture have a wood preservative. What should I do?
Remove as much of the existing finish as possible by sanding with around 120-grit paper, then apply the paint in thin coats until the finish is even.